MONACOR PA-4125DX/DT

characteristics

Dante® is a network protocol based on three-layer IP technology that provides a low-latency, high-precision, low-cost solution for point-to-point audio connections. Dante® technology can be used to transmit high-precision clock signals and audio signals, enabling complex routing on the Ethernet to ensure perfect sound, solving the problem of complicated cabling for traditional audio transmission and reducing costs. It can be adapted to an existing network without the need for special configuration.

Dante®-capable 4-zone multifunction amplifier

in Class-D technology with DSP and professional features for universal "multi-room" sound applications.
Clearly designed graphical HTML5 user interface with extensive functions. Convenient operation via a web browser, independently of the end device used (PC, Mac, iOS, Android, etc.).

• Dante® interface (4 transmit, 4 receive channels)
• 4 x 125 W zone (4/8 O) or 2 x 250 W (100 V)
• 100 V or 4/8 O operation
• 4 analog inputs Mic/Line via screw/plug connection (bal.) or RCA jacks
• 1 digital input/output via Cinch sockets S/PDIF
• 4 outputs (4/8 O) or 2 zone outputs (100 V) via screw/plug connection
• GPIO interface for remote volume and standby
• Network connection via LAN or WLAN
• Convenient operation and configuration via HTML5 user interface
• High-/low-pass with different filters
• parametric equalizer
• output with separate FIR filters
• Loudspeaker driver synchronization 10 ms
• Reversible output phase
• Adjustable compressor/limiter
• Adjustable delay
• Inputs can be mixed
• Talkover with priority routing
• Built-in sine-wave noise generator
• 5-band parametric equalizer for input
• Short-circuit, DC voltage, undervoltage, temperature and overload protection

System requirements Dante®: Windows 7/8.1/10 or MacOS 10.9.5/10.10.5/10.11

The Dante® trademark and any Dante® software integrated into these products have been licensed from Audinate Pty Ltd.

manufacturer information

MONACOR INTERNATIONAL Ltd.
To the wrong 36
28307 Bremen
Germany
[email protected]

Safety and warning instructions

The device is supplied with a dangerous mains voltage. Never try to repair the device yourself and never insert anything into the ventilation openings. There is a risk of electric shock.
During operation, the speaker terminals carry dangerous voltages of up to 100 V. Only connect or disconnect the amplifier when it is switched off.
Do not operate the device and immediately unplug the power plug from the socket if there is visible damage to the device or the power cable, if it is suspected to be defective after falling or similar, if malfunctions occur. In any case, take the device to a specialist workshop for repair.
Use the device only indoors and protect it from dripping and splashing water, high humidity and heat (permissible operating temperature range 0 - 40 °C).
Never pull the plug out of the socket by the cable; always hold the plug itself.
The heat generated in the device must be dissipated by air circulation. Therefore, do not cover the ventilation openings of the housing.
If the device is to be permanently withdrawn from use, it should be handed over to a local recycling company for environmentally friendly disposal.

Technical data