Ram Audio W 6000 DSP E AES PA Power Amplifier 2 x 3025 W 2 Ohms incl.

High End High-Power Amplifiers Utilizing state-of-the-art technology RAM Audio introduces the W Series 2 and 4-channel high end power amplifiers with output ratings up to 12 kW . Dual PFC QuantaPulse switched-mode power supplies provide increased, smooth output irrespective of mains fluctuations. Housed in 46 cm deep, 2U rackmountable reinforced steel chassis the 7 high-power models are easily portable weighing in at 10 - 12 kg only. The W Series features Neutrik XLR and Speakon connectors, a large blue LCD user interface and 13-detent digital encoders for convenient gain, bridge mode, input link and ICL setting. A DSP loudspeaker management system is optionally available. Main Features

• high-efficiency power amplifiers with up to 12 kW RMS output power
• regulated PFC QuantaPulse dual switch-mode power supply
• digital control with large blue LCD interface
• temperature and output level indication
• USB port for firmware updates and DSP control
• gain, bridge mode, input links and ICL configurable via 13-detent digital encoders on the front panel
• RAM Audio power management system (PMS)
• high-efficiency oversized output transistors for maximum reliability under extreme operating conditions
• easily removable front panel for dust filter cleaning, Neutrik XLR and Speakon connectors

PMS?: a complete Power Management System that monitors the essential parameters for safe operation. It precisely controls the power supply to the amplifier and output power under extreme and dangerous conditions:

• if the internal operating temperature approaches emergency shutdown during irregular operating conditions,
• if the power supply draws excessive current under laboratory conditions or during extended acoustic feedback.

ICL?: improved Intelligent Clip Limiting prevents loudspeaker damage while maintaining audio quality and punch under clipping conditions. QuantaPulse? Technology: The Soft Switching Resonant QuantaPulse Power Supply is designed to provide plenty of power when needed monitoring the necessary parameters of voltage and current for a controlled performance at all times. Bi-directional data flow between the power supply and power amp module. Two very important characteristics of the QuantaPulse power supply are the optimization against over-voltages and superior reliability.Specifications:

Product type:	Power Amplifiers
Type:	PA Power Amplifiers
Weight:	10,9 kg
Product type:	Power Amplifiers
Type:	PA Power Amplifiers
Rated ouput power (1kHz @ 2 Ohms):	2 x 3025 W
Rated ouput power (1kHz @ 4 Ohms):	2 x 1600 W
Rated ouput power (1kHz @ 8 Ohms):	2 x 820 W
Rated ouput power (1kHz @ 4 Ohms, bridged):	6050 W
Rated ouput power (1kHz @ 8 Ohms, bridged):	3200 W
Output circuitry:	Class H
Frequency response:	20 - 20000 Hz
THD:	< 0.05 %
Signal-to-noise ratio:	113 dB
Damping factor:	> 500
Crosstalk:	> 80 dB
Gain:	26 - 38 dB
Input sensitivity:	4.0 / 2.0 / 1.0 V
Input impedance:	(unbalanced) 10 k Ohm(s)
Input impedance:	(balanced) 20 k Ohm(s)
Protection circuits:	DC voltage
Protection circuits:	open outputs and speaker load mismatching
Protection circuits:	power on muting
Protection circuits:	short circuit
Protection circuits:	high frequency
Protection circuits:	on/off transients
Protection circuits:	Soft start
Protection circuits:	thermal overload
Controls:	dual/bridge switch
Controls:	Power
Controls:	2 x volume
Indicators:	temperature
Indicators:	Clipping
Indicators:	fault
Indicators:	ready
Indicators:	signal
Line inputs:	2
Line input connectors:	XLR
Line outputs:	2
Line output connectors:	XLR
Loudspeaker outputs:	2
Speaker output connections:	Speakon
Cooling:	fan
Operating voltage:	230 V
Power consumption @ full load:	7 A
Width:	483 mm
Height:	89 mm
Depth:	460 mm
Weight:	10 kg
Product type:	Power Amplifier Accessories
Type:	2-channel
AD/DA converter:	24 bit
Filter type:	Bessel
Filter type:	Butterworth
Filter type:	Linkwitz-Riley
Filter slew rate:	up to 48 dB/oct
Input EQ:	29 x graphic or parametric per channel
Output EQ:	20 filters per channel (parametric, shelving, LP, HP, BP, SB)
Input delay:	up to 80 m (230 ms) per input
Output Delay:	up to 18 m (50 ms) per channel
Limiter (per channel):	Peak Voltage Output (variable knee)
Limiter (per channel):	RMS Power
Additionakl DSP functions (per input):	Gain
Additionakl DSP functions (per input):	mute
Additionakl DSP functions (per input):	Phase Inversion
Additionakl DSP functions (per channel):	Gain
Additionakl DSP functions (per channel):	Phase Inversion
Additionakl DSP functions (per channel):	mute
Line inputs:	2
Line input connectors:	XLR (balanced)
Line outputs:	2
Line output connectors:	XLR (balanced)
Programming:	via USB port
Programming:	Ethernet (optional)
Other features:	Signal Generator (pink and white noise, sinus 20 Hz - 20,000 Hz)
Weight:	0,5 kg
Product type:	Power Amplifier Accessories
Connector:	RJ45
compatible with:	AMX®
compatible with:	Crestron®
compatible with:	Stardraw Control®
Weight:	0,6 kg
Product type:	Power Amplifier Accessories
Resolution and sampling rate:	16-bit or 24-bit selectable, 32 kHz - 96 kHz
Inputs:	1
Input connectors:	XLR
Weight:	0,3 kg