SHOWTEC Pixel Controller - G2 For Pixelstrip 20/40, Pixeltube 16/32 and Pixel Dot

The Showtec Pixel Controller G2 is an easy-to-use four-output RGB pixel controller with dimmer function, suitable for controlling a variety of Pixel products, like the Pixelstrip 20/40, Pixeltube 16/32 and Pixel Dot. This controller is not only externally controllable by DMX, Master/Slave, Art-Net, sACN and Kling-Net, but can also be used as a stand-alone controller with built-in programs.
Each output can transmit its own data stream, allowing for flexible signal routing. However, the controller must be configured to control one specific type of pixel product at a time. This means that while the outputs operate independently, all connected fixtures must be of the same model—mixing different types across outputs is not supported.
Depending on the selected control mode, each of the 4 outputs can handle up to 4 m (13.1 ft) Pixelstrip, 5 m (16.4 ft) Pixeltube or 40 Pixel Dots. When using Art-Net or sACN, you are able to gain full control of all pixels to create stunning effects.Technical data:

Control Mode:	Art-Net / Auto / DMX / Kling-Net / Manual / Master Slave / RDM / sACN
DMX Channels:	7 / 480 / 1920
Display:	OLED
Dimmer:	0-100 %
Strobe:	0-20 Hz
Power Supply:	100-240 V AC 50/60 Hz
Output voltage:	24 V DC
Power Consumption:	6 W
Max. power consumption:	320 W
Power Connector In:	Power Pro Blue
Power Connector Out:	Power Pro Grey
DMX Connector:	XLR 3P In/Out / XLR 5P In/Out
Data Connector:	RJ45 In/Out
Controller Height:	68 mm
Controller Width:	342 mm
Controller Length:	210 mm
Weight:	2.1 kg
IP Rating:	IP20 (indoor use only)
Housing:	Metal
Colour:	Black
Cooling:	Active
Mounting Options:	Clamp
Maximum Ambient Temperature:	40 °C
Minimum Ambient Temperature:	-5 °C
Included Cables:	Power Pro Cable